Digitron Easy Lock DMI18PG/B/A Manuel d'utilisation, d'entretien et d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation, d'entretien et d'installation pour {nom_de_la_catégorie} Digitron Easy Lock DMI18PG/B/A. Digitron Easy Lock DMI18PG/B/A 14 pages. Proximity lock rfid mifare 13,56 khz, bolt lenght - 13/18 mm

Imprimer la page

PERSONAL USE

It is possible program the lock so that it works with a specific personal TAG

( Card or Wristband ).

With the lock "open" lean the special READ FIXED card to the center of the sensor and

remove the card only when the the LED turns "ON".

Within 5 seconds ( before the LED turns "OFF" ) lean the personal compatible TAG

( Card or Wristband ) and remove the card only when the LED stays "ON" after has issued

short flashes.

After this procedure the lock will work only with the personal TAG ( Card or Wristband )

programmed.

Note : with the personal use mode when the lock is closed the led does not flashes

To return in the mode Shared Use :

With the lock "open" lean the special FIXED ERASED card to the centre of the sensor and

remove the card when the LED turns "ON".

After this procedure the lock closes with any compatible TAG ( Card or Wristband ) and

it will open only with the same TAG used to close

TIMER SETTING

By inserting the timer, the lock will open after an established time everytime it is closed.

To set the timer please follow the instruction below :

With the lock "open" lean the special TIMER with the value of the hours that you wish

to program to the center of the sensor and remove the card when the LED turns "ON".

When the lock is closed the LED will shortly flash 2 time every 2 seconds to indicate that

the lock is closed with the Timer "ON".

For disconnecting the Timer proceed as above and use the TIMER card with value "0".

PAG. 3