Cisco Performance Routing Engine 5 Manuel d'installation du matériel - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Performance Routing Engine 5. Cisco Performance Routing Engine 5 35 pages.
Également pour Cisco Performance Routing Engine 5 : Manuel de démarrage rapide (2 pages)
Imprimer la page
General Safety Guidelines
When you install any component in a chassis, observe all caution and warning statements mentioned in this chapter. For warning
translations, see the regulatory compliance and safety documentation that came with this product.
The following guidelines will help ensure your safety and protect the equipment. However, these guidelines may not cover all
potentially hazardous situations you may encounter during system installation, so be alert.
• Install your product in compliance with the national and local electrical codes. In the United States, this means the National Fire
Protection Association (NFPA) 70, United States National Electrical Code. In Canada, Canadian Electrical Code, part I, CC22.1.
In other countries, International Electrotechnical Commission (IEC) 364, part 1 through part 7.
• Review the safety warnings listed in the regulatory compliance and safety documentation before installing, configuring, or
performing maintenance on the product.
• Disconnect power at the source before you install or remove a chassis.
• Do not attempt to lift an object you might find too heavy to lift safely.
• Keep the chassis area clear and as dust free as possible during and after installation.
• Keep tools and chassis components away from walk areas.
• Do not wear loose clothing, jewelry (including rings and chains), or other items that could get caught in the chassis.
• Use the product in accordance with its marked electrical ratings and product usage instructions.
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement 1030.
Electrical Equipment Guidelines
• Before beginning any procedures requiring access to the chassis interior, locate the emergency power-off switch for the room
in which you are working.
• Disconnect all power and external cables before moving a chassis.
• Do not work alone in potentially hazardous conditions.
• Never assume that power has been disconnected from a circuit; always check.
• Do not perform any action that creates a potential hazard to people or makes the equipment unsafe.
• Carefully examine your work area for possible hazards such as moist floors, ungrounded power extension cables, and missing
safety grounds.
Preventing Electrostatic Discharge Damage
Electrostatic discharge (ESD) damage occurs when electronic cards or components are improperly handled, and can result in complete
or intermittent failures. All line cards consist of a printed circuit card that is fixed in a metal carrier. Electromagnetic interference
(EMI) shielding and connectors are integral components of the carrier. Although the metal carrier helps to protect the cards from
ESD, use an antistatic strap each time you handle the modules. Handle the carriers by the edges only; never touch the cards or connector
pins.
7