Cisco PIX 525 Manuel de l'utilisateur - Page 19

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Cisco PIX 525. Cisco PIX 525 30 pages. Security appliance
Également pour Cisco PIX 525 : Fiche technique (13 pages)

Imprimer la page
Cisco PIX 525 Manuel de l'utilisateur
Chapter 6
PIX 525
We highly recommend that you use a GE failover link when connecting the PIX 525 with GE interfaces.
Note
The Gigabit Ethernet circuit board and the fiber optic cable connection are shown in
Figure 6-19 Gigabit Ethernet Circuit Board
The Gigabit Ethernet circuit board has three LEDs:
•
•
•

Installing a DC Power Supply

Warning
Before performing any of the following procedures, ensure that power is removed from the DC circuit.
To ensure that all power is OFF, locate the circuit breaker on the panel board that services the DC
circuit, switch the circuit breaker to the OFF position, and tape the switch handle of the circuit
breaker in the OFF position.
To install the DC power supply, perform the following steps:
Place the power supply as shown in
Step 1
to feel the chassis hook engage with the slot on the bottom of the power supply.
Reinstall the three screws that secure the power supply on the back panel of the chassis.
Step 2
78-15170-02
TX—Transmitting data
RX—Receiving data
LINK—The Gigabit Ethernet circuit board has established a network connection
TX
RX
LIN K
Figure
6-20, and then slide it toward the rear panel. You will be able
Cisco PIX Security Appliance Hardware Installation Guide
Installing a DC Power Supply
Figure
6-19.
6-19