Cisco SCE 1000 and Manuel de démarrage rapide - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Cisco SCE 1000 and. Cisco SCE 1000 and 49 pages. Service control engine 1000 2xgbe
Imprimer la page
Summary Steps
1. Enter the time settings menu.
2. Configure the time zone name.
3. Specify the offset from UTC.
4. Confirm the local time and date.
5. Enter the SNTP configuration menu.
6. Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
7. Define the time interval between unicast updates.
8. Specify an IP address for the SNTP unicast server.
Detailed Steps
Enter the time settings menu.
Step 1
Would you like to enter the Time settings menu? [no]: y
Type
and press Enter.
y
Configure the time zone name.
Step 2
Type the time zone abbreviation and press Enter.
Enter time zone name [UTC]: CET
Specify the offset from UTC.
Step 3
Type the minutes offset from UTC and press Enter.
Enter time zone minutes offset from UTC: 60
Confirm the local time and date.
Step 4
The local time and date are displayed, and you are asked whether you want to change them
The local time and date is 15:00:01 CET FRI 01 July 2002
Would you like to set a new time and date? [no]:
If the time and date are correct, press enter and go to Step 5.
–
If the time and date are not correct, answer yes to the above question, and press Enter.
–
Would you like to set a new time and date? [no]: y
Confirm your response and type the new time and date.
This change will take effect immediately both on the system clock and calendar;
it will also set the time zone you entered. Are you sure? [yes/no]: y
Enter new local time and date: 14:00:01 1 July 2002
Time zone was successfully set.
The system clock and the calendar were successfully set.
Enter the SNTP configuration menu.
Step 5
If you do not wish to configure the SNTP, skip the rest of this section and go to Step 5: Configuring the DNS Settings,
page 20.
To enter the SNTP configuration dialog, type y, and press Enter
Would you like to enter the SNTP configuration menu? [no]: y
Configure the SNTP broadcast client. By default the SNTP broadcast client is not enabled.
Step 6
To disable the SNTP broadcast client, press Enter.
–
To enable the SNTP broadcast client, type y and press Enter.
–
Enable SNTP broadcast client? [no]:
19