Cisco UCS B200 M3 Manuel - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Cisco UCS B200 M3. Cisco UCS B200 M3 8 pages. Blade server
Également pour Cisco UCS B200 M3 : Manuel d'installation (34 pages), Note d'installation et d'entretien (36 pages), Note d'installation et d'entretien (37 pages), Manuel de mise à jour (21 pages), Note d'installation et d'entretien (28 pages)
Imprimer la page
Boot-Time Configuration
Example commands for setting fnic_max_qdepth to 128:
RHEL 6 .x / SLES11 / XS
1 . In /etc/grub .conf, append fnic .fnic_max_qdepth=<value> to the kernel line:
kernel /vmlinuz-2 .6 .32-358 .el6 .x86_64 ro root=/dev/mapper/vg_craigsrh-lv_root rd_NO_LUKS LANG=en_US .UTF-8
rd_NO_MD SYSFONT=latarcyrheb-sun16 crashkernel=auto rd_LVM_LV=vg_craigsrh/lv_swap rd_LVM_LV=vg_craigsrh/
lv_root KEYBOARDTYPE=pc KEYTABLE=us rd_NO_DM rhgb quiet
2 . Reboot for the new fnic_max_qdepth to take effect .
RHEL 5 .x
1 . In /etc/modprobe .conf, add an "options fnic" line to set fnic_max_qdepth at boot time:
options fnic fnic_log_level=4 fnic_trace_max_pages=128 fnic_max_qdepth=128
2 . Rebuild initrd:
mkinitrd -v -f /boot/initrd-`uname -r` .img `uname –r`
3 . Reboot for the new fnic_max_qdepth to take effect .
ESX 5 .x
1 . Set fnic_max_qdepth by running the following command in ESX 5 CLI:
# esxcli system module parameters set –p fnic_max_qdepth=128 –m fnic
2 . Reboot for the new fnic_max_qdepth to take effect .
Load-Time Configuration
RHEL / SLES11 / XS
1 . Run one of the following commands at the CLI:
# modprobe fnic fnic_max_qdepth=128
or
# insmod fnic .ko fnic_max_qdepth=128
Run-Time Configuration
RHEL / SLES11 / XS
1 . Configure fnic_max_qdepth with sysfs entry with the following command at the CLI:
# echo 128 > /sys/module/fnic/parameters/fnic_max_qdepth
5 © 2014 Cisco and/or its affiliates . All rights reserved .
fnic .fnic_max_qdepth=128