Cisco UCS B200 M3 Manuel de mise à jour - Page 8
Parcourez en ligne ou téléchargez le pdf Manuel de mise à jour pour {nom_de_la_catégorie} Cisco UCS B200 M3. Cisco UCS B200 M3 21 pages. Blade server
Également pour Cisco UCS B200 M3 : Manuel d'installation (34 pages), Note d'installation et d'entretien (36 pages), Note d'installation et d'entretien (37 pages), Manuel (8 pages), Note d'installation et d'entretien (28 pages)
Imprimer la page
Cisco UCS Blade Server
Cisco UCS Manager is now able to complete auto-discovery of the server.
Use Cisco UCS Manager 2.1(3a) to upgrade and activate the server CIMC to version 2.1(3a) or later.
Step 9
Use the procedures in the GUI or CLI
Step 10
Wait for the server to be discovered and by Cisco UCS Manager.
Step 11
Perform a board controller activation by using the Cisco UCS Manager CLI interface. Use the following
sequence of commands:
Note
Note
# scope server <chassis/server>
# scope boardcontroller
# show image
# activate firmware <boardcontroller version>.0 force
# commit-buffer
See also
Do not continue with the next step until the board controller activation completes. Verify whether the
Step 12
activation is complete by using the show version command.
As shown in the example below, wait until the Activate-Status returns Ready. This process takes a few
minutes before Activate-status is successfully completed and returns Ready.
# show version
BoardController:
Running-Vers: 8.0
Package-Vers:
Activate-Status: Ready
Clear the WILL_BOOT_FAULT
Step 13
In the Navigation pane, click the Equipment tab.
a.
On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose
b.
your server.
In the Work pane, click the General tab.
c.
In the Actions area, click Recover Server.
d.
In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.
e.
Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the server. This
takes two to three minutes. At the end of this process the WILL_BOOT_FAULT is cleared.
Cisco UCS B-Series Servers Upgrade Guide for Intel E5-2600/E5 2400 v2 Series CPUs
8
The server automatically reboots after the
The
command in the sequence below lists the board controller versions available for
show image
the server. Always activate the latest board controller image version when you use the
command.
activate firmware
Sample Board Controller Activation Command Sequence, page
by
Firmware Management Guide, Release
commit-buffer
using the Cisco UCS Manager GUI to reset the server CIMC:
2.1.
command is executed.
15.
OL-28629-02