Cisco UCS B200 M3 Note d'installation et d'entretien - Page 22

Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B200 M3. Cisco UCS B200 M3 28 pages. Blade server
Également pour Cisco UCS B200 M3 : Manuel d'installation (34 pages), Note d'installation et d'entretien (36 pages), Note d'installation et d'entretien (37 pages), Manuel (8 pages), Manuel de mise à jour (21 pages)

Step 3

Tighten the captive screw.

To remove a VIC, reverse the above procedure. You might find it helpful when removing the connector from

Tip

the motherboard to gently rock the board along the length of the connector until it loosens.

Figure 19: Installing a VIC mLOM Adapter

Installing an Adapter Card

All the supported mezzanine cards have a common installation process. These cards are updated frequently. Currently supported

cards and the available models for this server are listed in the specification sheets at this URL:

http://www.cisco.com/c/en/us/products/servers-unified-computing/ucs-b-series-blade-servers/datasheet-listing.html

If you are switching from one type of adapter card to another, before you physically perform the switch make sure that you download

the latest device drivers and load them into the server's operating system. For more information, see the firmware management chapter

of one of the Cisco UCS Manager software configuration guides.

Procedure

Step 1

Position the adapter board connector above the motherboard connector and align the two adapter captive screws to the

standoff posts (see callout 1) on the motherboard.

Step 2

Firmly press the adapter connector into the motherboard connector (see callout 2).

Step 3

Tighten the two captive screws (see callout 3).

Tip

Removing an adapter card is the reverse of installing it. You might find it helpful when removing the connector

from the motherboard to gently rock the board along the length of the connector until it loosens.