Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) Manuel d'installation et de configuration - Page 24
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et de configuration pour {nom_de_la_catégorie} Cisco Versatile Interface Processor (VIP6-80) (VIP6-80). Cisco Versatile Interface Processor (VIP6-80) (VIP6-80) 40 pages. Versatile interface processor
Imprimer la page
Connecting Cables to the Port Adapter
Refer to the Installation and Configuration Guide that shipped with your specific port adapter for cabling
instructions.
Installing a VIP6-80
This section describes the procedure for installing a VIP6-80, or for inserting an interface filler.
To ensure compliance with EMI approvals by providing a tight EMI seal for the Cisco 7500 and the Cisco
Note
7000 series routers, install interface processors first in the interface processor slots closest to the RSP
slots, and then work out to the interface processor slots furthest from the RSP slots. Refer to the
Description" section on page 3
If you removed a VIP6-80 and do not intend to replace it with another VIP in its slot, follow this
procedure to insert an interface processor filler in the empty slot.
Figure 3
shows proper handling of the VIP6-80 during installation.
Remove or insert only one VIP6-80 at a time. Disrupting the sequence before the system has completed
Caution
verification can cause the system to detect spurious hardware failures.
Use the following procedure to install a new VIP6-80:
Attach an ESD-preventive wrist strap between you and an unpainted chassis surface, if you have not
Step 1
already done so.
Ensure that a console terminal is connected to the console port (on the RSP or RSP7000) and that your
Step 2
console is turned on, or that you have a reliable Telnet connection to the system.
Hold the VIP6-80 handle with one hand and place your other hand under the carrier to support the
Step 3
VIP6-80 and guide it into the slot. (See
Caution
To prevent ESD damage, handle interface processors by the handles and carrier edges only, similar to
that shown for port adapters in
Place the back of the VIP6-80 in the slot and align the notch on the carrier with the groove in the slot.
Step 4
(See
While keeping the VIP6-80 parallel to the backplane, carefully slide it into the slot until the back of the
Step 5
faceplate makes contact with the ejector levers, and then stop. (See
Use the ejector levers when installing or removing interface processors. An interface processor that is
Caution
partially seated in the backplane might cause the system to hang and subsequently crash, and shoving or
slamming the interface processor into the slot can damage the backplane pins and board.
Versatile Interface Processor (VIP6-80) Installation and Configuration Guide
24
shows the functional details of inserting the VIP6-80 and using the ejector levers.
Figure
3.)
for more information on the interface processor slots on your router.
Figure
2.) Avoid touching the card or any connector pins.
Figure
4.
Figure 2
Figure
3b.)
OL-5078-01
"Product