Cisco 2500 Series Manuel de démarrage - Page 20

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco 2500 Series. Cisco 2500 Series 47 pages. Wireless controller
Également pour Cisco 2500 Series : Manuel d'installation (12 pages), Manuel de configuration (19 pages), Manuel de déploiement (23 pages), Manuel de configuration (50 pages)

Figure 12

Installing a Security Lock

The controller has a security slot on the back panel. You can install an optional customer-supplied cable

lock, such as the type that is used to secure a laptop computer, to secure the controller. Refer to

for the location of the security lock.

Running the Bootup Script and Power-On Self Test

When you plug the controller into an AC power source, the bootup script initializes the system, verifies

the hardware configuration, loads its microcode into memory, verifies its operating system software

load, and initializes itself with its stored configurations. Before performing this test, you should have

connected your PC to the CLI console on the controller as described in the

Console Port" section on page

To run the bootup script and conduct the power-on self test (POST), follow these steps:

Plug the external power supply into the power jack on the back of the controller.

Step 1

Plug a country-specific power cord into the external power supply, then plug the other end into a

Step 2

grounded 100 to 240 VAC, 50–60 Hz electrical outlet.

Cisco 2500 Series Wireless Controller Getting Started Guide

Securing the Power Adapter Cable

Security clip secured with screw

AC/DC power adapter cable

If you wish to run a previous release of the controller code, press Esc when the boot loader

Note

prompt appears. The Bootloader Options menu appears.

Power plugged into the POWER 48VDC port.

18.

Figure 3

"Connecting the Controller