Cisco 2600 Series Manuel d'installation - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 2600 Series. Cisco 2600 Series 12 pages. Configuring adsl wic to support pppoe clients
Également pour Cisco 2600 Series : Notes de mise à jour (32 pages), Configuration (15 pages), Note d'application (41 pages), Fiche technique (6 pages), Annexe (15 pages), Manuel d'installation (22 pages), Vue d'ensemble (13 pages), Manuel de démarrage rapide (2 pages), Manuel (5 pages)

Installing the Redundant Power Supply Adapter Plate

Figure 11

Replacing the Cover

Take the following steps to replace the cover:

Step 1

Step 2

Caution

one end and then the other, working back and forth; however, use care to prevent bending

of the chassis edges.

Step 3

Step 4

Step 5

Step 6

10 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Reconnecting the Connectors

Six-pin

connector

Position the two chassis sections, as shown in Figure 2.

Referring to Figure 2, press the two chassis sections together and ensure the following:

•

The top section ﬁts into the rear of the bottom section. The bottom section ﬁts into the

front of the top section.

•

Each side of the top and bottom sections ﬁts together.

To ﬁt the two sections together, it might be necessary to work them together at

When the two sections ﬁt together snugly, slide the chassis top so until it ﬁts into the front

bezel.

Replace the cover screws. Tighten the screws to no more than 8 or 9 inches/pound of

torque.

Reinstall the chassis on the wall, rack, desktop, or table.

Reconnect all cables.