Cisco 6400 Manuel d'installation - Page 26

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco 6400. Cisco 6400 34 pages. Video surveillance 6400 ip camera
Également pour Cisco 6400 : Fiche technique (8 pages)

Imprimer la page

Adjusting the IP Camera Focus and Zoom

To adjust the IP camera focus and zoom, perform the following steps while viewing video from the

camera. For information about viewing video, see

Procedure

Step 1

The Home window appears.

Click the View Video link.

Step 2

The Camera Video & Control window appears.

Verify that the field of view is correctly set.

Step 3

Click the Focus/Zoom toggle button located below the video pane.

Step 4

The focus and zoom controls appear.

Step 5

While watching the video pane, perform the following steps:

Step 6

(Optional) Click Auto Focus to have the IP camera automatically adjust its focus. To automatically

Step 7

adjust the focus to a particular region in the field of view, check the Specify Region check box and draw

or select a region before clicking Auto Focus.

Powering the IP Camera On or Off

The IP camera does not include an on/off switch. You power it on or off by connecting it to or

disconnecting it from a power source. When you power off the IP camera, configuration settings are

retained.

To power on the IP camera, take either of these actions:

•

To power off the IP camera, take either of these actions:

•

Resetting the IP Camera

You reset the IP camera by pressing the Reset button on the IP Camera (see

There are various reset types, as described in

Cisco Video Surveillance 6400 IP Camera Installation Guide

4-4

Move the Zoom slider until you achieve the desired zoom level.

Move the Focus slider until the video image is at its sharpest.

Use an STP (shielded twisted pair) Category 5 or higher network cable to connect the IP camera to

a network switch that provides 802.3af compliant PoE.

Use an optional 12 VDC or 24VAC power adapter to connect the IP camera to a wall outlet

If the IP camera is receiving PoE, disconnect the network cable

If the IP camera is receiving power through the power adapter, unplug the adapter from the wall or

disconnect it from the camera

"Viewing Live Video" section on page

Table

4-3.

Chapter 4

Camera Management

4-5.

Figure 1-1 on page

1-2).

OL-28494-01