Cisco Firepower 1120 Manuel d'installation du matériel - Page 38

Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco Firepower 1120. Cisco Firepower 1120 42 pages. Connected grid router
Également pour Cisco Firepower 1120 : Manuel d'installation du matériel (30 pages), Manuel d'installation (6 pages), Manuel de démarrage rapide (10 pages), Manuel (6 pages), Manuel d'installation du matériel (42 pages), Manuel de déploiement (8 pages), Pour commencer (42 pages)

Install the FIPS Opacity Shield in a Two-Post Rack

Figure 26: Remove and Install an SSD

Step 3

Tighten the thumb screws on both sides of the SSD bay.

Step 4

Check the SSD LED to make sure the SSD is seated properly and functioning. See

description of the SSD LED.

Install the FIPS Opacity Shield in a Two-Post Rack

Note

Before you begin

Caution

You need the following items to install the FIPS opacity shield:

• #1 Phillips screwdriver

• The following items from the FIPS kit (part number 800-105495-01):

Cisco Firepower 1100 Series Hardware Installation Guide

Because the FIPS opacity shield covers the serial number on the chassis, the CO should copy the serial

number and store it in a secure place. The serial number is needed when you call Cisco TAC.

This procedure should be performed only by the Crypto Officer (CO).

Installation, Maintenance, and Upgrade

Rear Panel LEDs, on page 9

for a