Cisco Firepower 2130 Pour commencer - Page 27
Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} Cisco Firepower 2130. Cisco Firepower 2130 42 pages. Rack-mount and ground the chassis
Également pour Cisco Firepower 2130 : Manuel (12 pages), Manuel de déploiement (8 pages), Installation & Maintenance (26 pages)
Imprimer la page
Getting Started
Setting
Management gateway.
DNS servers for the management interface.
Inside interface IP address.
DHCP server for inside clients.
DHCP auto-configuration for inside clients.
(Auto-configuration supplies clients with
addresses for WINS and DNS servers.)
Default
The data interfaces on the device. Typically
the outside interface becomes the route to
the Internet. This gateway works for
from-the-device traffic only. If the device
receives a default gateway from the DHCP
server, then that gateway is used.
Firepower 4100/9300: Set the gateway IP
address when you deploy the logical device.
ISA 3000: 192.168.45.1.
FTDv: 192.168.45.1
The OpenDNS public DNS servers, IPv4:
208.67.220.220 and 208.67.222.222; IPv6:
2620:119:35::35. DNS servers obtained
from DHCP are never used.
Firepower 4100/9300: Set the DNS servers
when you deploy the logical device.
192.168.95.1/24
Firepower 4100/9300: Data interfaces are
not pre-configured.
ISA 3000: BVI1 IP address is not
preconfigured. BVI1 includes all inside and
outside interfaces.
FTDv: 192.168.45.1/24
Running on the inside interface with the
address pool 192.168.95.5 -
192.168.95.254.
Firepower 4100/9300: No DHCP server
enabled.
ISA 3000: No DHCP server enabled.
FTDv: The address pool on the inside
interface is 192.168.45.46 -
192.168.45.254.
Enabled on outside interface.
Default Configuration Prior to Initial Setup
Can be changed during initial
configuration?
No.
For Firepower 4100/9300: Yes.
Yes
No.
No.
Yes, but indirectly. If you configure a static
IPv4 address for the outside interface,
DHCP server auto-configuration is
disabled.
Getting Started
27