Cisco Firepower Management Center 1500 Manuel de démarrage - Page 29
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Firepower Management Center 1500. Cisco Firepower Management Center 1500 42 pages. Firepower management center
Imprimer la page
Table 3
Restore Menu Options
Option
1 IP Configuration
2 Choose the transport
protocol
3 Select Patches/Rule
Updates
4 Download and Mount
ISO
5 Run the Install
6 Save Configuration
7 Load Configuration
8 Wipe Contents of Disk
Navigate the menu using your arrow keys. To select a menu option, use the up and down arrows. Use the right and
left arrow keys to toggle between the
The menu presents two different kinds of options:
To select a numbered option, first highlight the correct option using the up and down arrows, then press Enter
while the
button at the bottom of the page is highlighted.
OK
To select a multiple-choice (radio button) option, first highlight the correct option using the up and down keys,
then press the space bar to mark that option with an
button is highlighted.
In most cases, complete menu options
software and intrusion rule updates during the restore process.
If you are restoring an appliance to a different major version from the version currently installed on the appliance,
a two-pass restore process is required. The first pass updates the operating system, and the second pass installs
the new version of the system software.
If this is your second pass, or if the restore utility automatically loaded the restore configuration you want to use,
you can start with menu option
However, Cisco recommends you double-check the settings in the restore configuration before proceeding.
Note:
To use a previously saved configuration, start with menu option
Configurations, page
Files and Mounting the Image, page
To restore an appliance using the interactive menu, use the following steps:
1.
1 IP Configuration
2.
2 Choose the transport protocol
Cisco Firepower Management Center Getting Started Guide
Description
Specify network information about the
management interface on the appliance you
want to restore, so that the appliance can
communicate with the server where you placed
the ISO and any update files.
Specify the location of the ISO image you will use
to restore the appliance, as well as any
credentials the appliance needs to download the
file.
Specify a system software and intrusion rules
update to be applied after the appliance is
restored to the base version in the ISO image.
Download the appropriate ISO image and any
system software or intrusion rule updates. Mount
the ISO image.
Invoke the restore process.
Save any set of restore configurations for later
use, or load a saved set.
Securely scrub the hard drive to ensure that its
contents can no longer be accessed.
and
OK
1
,
2
,
4
:
Downloading the ISO and Update Files and Mounting the Image, page
34. After you load the configuration, skip to menu option
32.
— see
Identifying the Appliance's Management Interface, page
— see
Specifying ISO Image Location and Transport Method, page
Restoring a Firepower Management Center to Factory Defaults
buttons at the bottom of the page.
Cancel
. To accept your selection, press Enter while the
X
4
, and
5
, in order. Optionally, add menu option
For more information, see...
Identifying the Appliance's
Management Interface, page 30
Specifying ISO Image Location and
Transport Method, page 30
Updating System Software and
Intrusion Rules During Restore,
page 31
Downloading the ISO and Update Files
and Mounting the Image, page 32
Invoking the Restore Process, page 32
Saving and Loading Restore
Configurations, page 34
Scrubbing the Hard Drive, page 41
3
to install system
:
Saving and Loading Restore
6
4
:
Downloading the ISO and Update
30.
OK
32.
30.
29