Cisco Firepower Management Center 3500 Manuel de démarrage - Page 19
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Firepower Management Center 3500. Cisco Firepower Management Center 3500 42 pages. Firepower management center
Imprimer la page
By default, the Management Center also has a health policy applied. A health policy, as part of the health
monitoring feature, provides the criteria for the system continuously monitoring the performance of the
appliances in your deployment. Cisco recommends that you use the Management Center to apply a health
policy to all the devices it manages.
Software and Database Updates
You should update the system software on your appliances before you begin any deployment. Cisco
recommends that all the appliances in your deployment run the most recent version of the Firepower System.
If you are using them in your deployment, you should also install the latest intrusion rule updates, VDB, and
GeoDB. For Versions 6.5+, the Initial Configuration Wizard automatically configures some of these update
activities for you; see
Caution:
Before you update any part of the Firepower System, you must read the release notes or advisory
text that accompanies the update. The release notes provide important information, including supported
platforms, compatibility, prerequisites, warnings, and specific installation and uninstallation instructions.
Redirecting Console Output
By default, Management Centers direct initialization status, or init, messages to the VGA port. If you want to use
the physical serial port or SOL to access the console, Cisco recommends you redirect console output to the serial
port after you complete the initial setup.
To redirect console output using the shell, you run a script from the appliance's shell.
Using the Shell to Redirect the Console Output
Procedure
1.
Using your keyboard/monitor or serial connection, log into the appliance's shell using an account with
Administrator privileges. Use the steps appropriate to your Firepower version; see
Linux Shell on the FMC, page
The prompt for the appliance appears.
2.
At the prompt, set the console output by typing one of the following commands:
—
To access the appliance using the VGA port:
sudo /usr/local/sf/bin/configure_console.sh vga
—
To access the appliance using the physical serial port:
sudo /usr/local/sf/bin/configure_console.sh serial
—
To access the appliance using LOM via SOL:
sudo /usr/local/sf/bin/configure_console.sh sol
3.
To implement your changes, reboot the appliance by typing
The appliance reboots.
Using the Web Interface to Redirect the Console Output
Procedure
1.
Select
System > Configuration.
Cisco Firepower Management Center Getting Started Guide
Automatic Initial Configuration, page 9
3.
Redirecting Console Output
for more information.
Accessing the CLI or the
.
sudo reboot
19