Cisco Firepower Management Center 3500 Manuel de démarrage - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Firepower Management Center 3500. Cisco Firepower Management Center 3500 42 pages. Firepower management center
Imprimer la page
2.
Use a web browser to navigate to the appliance's IP address:
https://<Management IP Address>
The login page appears.
3.
Log in to the web interface using
is case-sensitive.)
What to Do Next
Complete the setup process using the procedures in
Wizard, page
Access the Firepower Management Center Using a Keyboard and
Monitor
You can connect a USB keyboard and VGA monitor to the appliance, which is useful for rack-mounted appliances
connected to a keyboard, video, and mouse (KVM) switch. The FMC management interface is pre-configured to
accept an IPv4 address assigned by DHCP, but failing to obtain a DHCP lease, the management interface uses a
fallback IPv4 address of192.168.45.45. If your network does not use DHCP and your PC cannot reach that
address, we recommend you perform the initial setup by connecting to the FMC directly as described in
the Firepower Management Center Using the Management Interface, page
Before You Begin:
Determine the IP address assigned to the management interface of the FMC:
If you are setting up a new FMC for the first time, check with your network administrator to determine the IP
address that DHCP will assign to the FMC's MAC address when you connect it to the local network. (You can
find the MAC address on a label or pullout card on the appliance.)
If no DHCP is present, or if the DHCP has no free addresses in its pool, the FMC management interface uses
the IP address 192.168.45.45. In this case if your PC cannot reach that address we recommend you perform
the initial setup by connecting to the FMC directly as described in
Using the Management Interface, page
If you are connecting to an FMC for the first time after performing a System Restore (see
Management Center to Factory Defaults, page
IP address is the same as it was before you performed the System Restore.
Procedure
1.
Using the supplied Ethernet cable, connect the management interface on the back of the FMC to a protected
management network.
2.
Use a web browser to navigate to the FMC web interface login page:
https://<Management IP Address>
The login page appears.
3.
Log into the web interface using
is case-sensitive.
What to Do Next
Complete the setup process using the procedures in
Wizard, page
Cisco Firepower Management Center Getting Started Guide
admin
7.
as the username and
admin
7.
as the username and
Admin123
Firepower Management Center Initial Configuration
5.
22) and you chose to retain license and network settings, the
Admin123
Firepower Management Center Initial Configuration
Installation and Initial Setup for Versions 6.5+
as the password. (Note the password
5.
Access the Firepower Management Center
Restoring a Firepower
as the password. Note that the password
Access
6