Cisco Firepower Management Center 750 Manuel de démarrage - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel de démarrage pour {nom_de_la_catégorie} Cisco Firepower Management Center 750. Cisco Firepower Management Center 750 42 pages. Firepower management center
Imprimer la page
sudo ipmitool -I lanplus -H IP_address -U username sol activate
For ipmiutil, type:
sudo ipmiutil sol -a -V4 -J3 -N IP_address -U username -P password
Where IP_address is the IP address of the management interface on the appliance, username is user name of
an authorized LOM account, and password is the password for that account. Note that IPMItool prompts you
for the password after you issue the sol activate command.
3.
Reboot the appliance; type
4.
Monitor the reboot status.
If the system is performing a database check, you may see the following message:
The system is not operational yet. Checking and repairing database are in progress.
This may take a long time to finish.
When you see the BIOS boot options, press Tab slowly and repeatedly (to prevent the appliance from booting
the currently installed version of the system) until the LILO boot prompt appears. For example:
GNU/Linux - LILO 24 - Boot Menu
6.1.0
System_Restore
Restore_Serial
5.
At the boot prompt, start the restore utility by typing Restore_Serial.
The boot prompt appears after the following choices:
0. Load with standard console
1. Load with serial console
6.
Type
and press Enter to load the interactive restore menu via the appliance's serial connection.
1
Note:
If you do not select a display mode, the restore utility defaults to the standard console after 30 seconds.
7.
Press Enter to confirm the copyright notice.
8.
Unless this is the first time you have restored the appliance to this major version, the utility automatically loads
the last restore configuration you used. To continue, confirm the settings in a series of pages until the "Cisco
Firepower Appliance <Version> Configuration Menu" appears.
What to Do Next
Continue with
Using the Interactive Menu to Restore an Appliance
The restore utility for Firepower devices uses an interactive menu to guide you through the restoration.
Note:
Only reimage your appliances during a maintenance window. Reimaging resets appliances in bypass mode
to a non-bypass configuration and disrupts traffic on your network until you reconfigure bypass mode. For more
information, see
Traffic Flow During the Restore Process, page
The menu displays the options listed in the following table.
Cisco Firepower Management Center Getting Started Guide
sudo reboot.
Using the Interactive Menu to Restore an Appliance, page
Restoring a Firepower Management Center to Factory Defaults
Provide the
password when prompted.
admin
24.
28.
28