Cisco Nexus 7000 Series Manuel d'instructions d'installation - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions d'installation pour {nom_de_la_catégorie} Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 39 pages. Switch chassis
Également pour Cisco Nexus 7000 Series : Manuel de référence (2 pages), Référence (34 pages), Manuel d'installation (18 pages), Configuration (8 pages), Manuel de configuration (28 pages), Manuel de démarrage rapide (10 pages), Manuel de démarrage rapide (29 pages), Manuel d'instructions de remplacement (14 pages), Manuel d'instructions de remplacement (21 pages), Manuel d'installation (16 pages), Manuel de dépannage (10 pages)

After you install both brackets in the rack, you must connect the spanner bar on each bracket to the

opposite bracket. The spanner bars are required to prevent both ends of the brackets (at the front and

rear of the rack) from separating or drifting apart. The cutouts in the brackets are to accommodate

the ear brackets that attach to the chassis to the rack. (Refer to Figure 2 on page 4.)

To install the brackets in the rack, you will secure each bracket to a rack post with three

10-32 x 5/8-inch Phillips, pan-head screws. If possible (if the holes line up), use the top-most and

bottom most mounting holes in the bracket. Always use the bottom mounting hole on the bracket. If

the top mounting hole does not line up with a hole in the rack post, use one of the other two holes

near the top of the bracket.

Mounting the Brackets to the Rack Posts

Follow these steps to mount each bracket to a rack post:

Step 1

Step 2

Step 3

Figure 10

Measure the space between the inner edges of the left front and right front equipment

rack-mounting posts to ensure that it is at least 17.72 inches. The chassis is 17.5 inches wide

and must ﬁt between the mounting posts.

Measure the distance between the holes in the mounting posts to ensure that it is

18.31 inches ( .063 inches). Make several measurements down the length of the posts to

ensure they are parallel.

Holding the ﬁrst bracket in the position shown in Figure 10, place the bracket on the inner

side of the rack post, with the ﬂanged front edge of the bracket in front of the rack post.

Installing a Bracket on a Rack Post—Left Bracket Shown

Rack post

Flange

Cisco 7000 and Cisco 7507 Rack-Mount Kit Installation Instructions

Installation