Cisco ONS 15454 Installer - Page 24

Parcourez en ligne ou téléchargez le pdf Installer pour {nom_de_la_catégorie} Cisco ONS 15454. Cisco ONS 15454 32 pages. Four-shelf and zero-shelf bay assembly
Également pour Cisco ONS 15454 : Manuel d'instructions d'installation (22 pages), Installer (32 pages), Déballage et installation (42 pages), Déballage et installation (40 pages)

Imprimer la page
Cisco ONS 15454 Installer
NTP-A11 Install the Rear Cover
Table 1-4
EIA Type
UBIC-V
UBIC-H
MiniBNC
BNC
High-Density BNC
SMB
AMP Champ
Note
Step 3
Locate the mounting holes where you will install the standoffs on the EIAs you are using.
shows the mounting holes on the UBIC-V.
Figure 1-10
identify the mounting holes on all EIAs by locating the REAR COVER BRACKET LOCATION
designation.
Cisco ONS 15454 Procedure Guide, R5.0
1-24
Standoffs Required for EIA Types
Required Standoffs for
One Extended Standoff
One 1 3/8-inch
Two 2-inch
One 1 3/8-inch
One 2-inch
One 1 3/8-inch
One 2-inch
One 1 3/8-inch
One 1-inch
As needed, attach additional standoffs to the extended standoffs to meet site-specific cable
management requirements.
shows the mounting holes on the remaining EIA types (MiniBNC, SMB, etc.). You can
Chapter 1
Total Required
Standoffs per Shelf
Four 1 3/8-inch
Eight 2-inch
Four 1 3/8-inch
Four 2-inch
Four 1 3/8-inch
Four 2-inch
Four 1 3/8-inch
Four 1-inch
Figure 1-9
shows the mounting holes on the UBIC-H.
Install the Shelf and Backplane Cable
Figure 1-8
March 2005