Cisco UCS B200 M4 Manuel de mise à jour - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de mise à jour pour {nom_de_la_catégorie} Cisco UCS B200 M4. Cisco UCS B200 M4 9 pages. For e5-2600 v4 series cpus
Également pour Cisco UCS B200 M4 : Note d'installation et d'entretien (30 pages), Note d'installation et d'entretien (46 pages), Manuel d'entretien (24 pages)

Imprimer la page

Introduction

Use the procedures in the

Step 4

Reinsert the server into the chassis.

Step 5

Wait for Cisco UCS Manager to automatically discover the server.

Note

At this point, the Health LED os the server shows a critical fault and Cisco UCS Manager reports a generic error

message:

activation is required, which is described in the next step.

Step 6

Wait for Cisco UCS Manager to automatically activate the board controller version.

Step 7

Do not continue with the next step until the board controller activation completes. Verify if the activation is complete

by using the

show version

Wait until Activate-Status returns Ready. This process takes a few minutes before it successfully completes and returns

Ready.

# show version

BoardController:

Runnning-Vers: x.0

Package-Vers:

Activate-Status: Ready

Step 8

Use the Cisco UCS Manager GUI to clear the WILL_BOOT_FAULT and reset the server CIMC:

a) In the Navigation pane, click the Equipment tab.

b) On the Equipment tab, expand Equipment > Chassis > Chassis number > Servers, then choose your server.

c) In the Work pane, click the General tab.

d) In the Actions area, click Recover Server.

e) In the Recover Server dialog, click Reset CIMC (Server Controller), then click OK.

Wait for CIMC to reboot and for Cisco UCS Manager to do a shallow discovery of the sever. This process take two to

three minutes. At the end of this process, the WILL_BOOT_FAULT is cleared

The Cisco UCS Manager bundle, including the server CIMC and BIOS, is backward-compatible with earlier

Note

supported CPUs. As a result, the following firmware downgrade steps are optional.

Step 9

(Optional) Downgrade the server CIMC. Use the procedures in the appropriate upgrade guide (depending on your current

software version):

Step 10

(Optional) Downgrade the server BIOS. Use the procedures in the appropriate upgrade guide (depending on your current

software version):

Cisco UCS B200 M4 Blade Server Installation and Service

WILL_BOOT_FAULT: Sensor failure asserted.

command.

Cisco UCS Manager Upgrade

Downgrading from Intel E5-2600 v4 Series CPUs to E5-2600 v3 Series CPUs

This message indicates that a board controller

Guides.

Cisco UCS B200 M4 Server Upgrade Guide for E5-2600 v4 Series CPUs

Note.