finder 19 Series Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} finder 19 Series. finder 19 Series 17 pages. Knx actuator

1.5.1.3

When the PAR_Function

ON/OFF = On message the channel starts to blink following PWM mode with the ON status

duration set by the PAR_Blink On (s) parameter and the OFF one by the PAR_Blink Off (s)

parameter. The values of these durations can be changed run-time via the DPT_Channel X-

Blink On Time (s) and DPT_Channel X- Blink Off Time (s) messages without overwriting

parameters values. The blinking cycle always begins with the full execution of the ON time

programmed. In the figure are not shown the DPT_Channel X - Status Inverted messages

that are sent as well from the device in correspondence with the status changing.

1.5.1.4

When the PAR_Function pa

Set ON/OFF = On message the channel status, if it was OFF, switches ON after a time set by

PAR_On Delay (s) parameter. The subsequent receipt of the message with the Off value

switches channel status from ON to OFF immediately. If the channel status is ON and the

device receives again the message DPT_Channel X

once delay has elapsed the DPT_Channel X - Status and DPT_Channel X - Status Inverted

messages will be sent on the bus. The delay time can be changed run-time via the

DPT_Channel X

are not shown the DPT_Channel X - Status Inverted messages that are sent as well from the

device in correspondence with the status changing. The functioning with the PAR_Function

DPT_Channel X Set ON/OFF = Off message, while the activation takes place immediately.

FINDER SpA

switching example

On d

switching example

On Delay (s) message without overwriting parameter value. In the figure

Ver. 2018

Blinking . By receiving the DPT_Channel X Set

Set ON/OFF = On, the cycle restarts and

is similar. In this case the delay starts by receiving the

KNX Actuator 19.6K

By receiving the DPT_Channel X