Cisco UCS B460 M4 Note d'installation et d'entretien - Page 18

Parcourez en ligne ou téléchargez le pdf Note d'installation et d'entretien pour {nom_de_la_catégorie} Cisco UCS B460 M4. Cisco UCS B460 M4 50 pages. Blade server
Également pour Cisco UCS B460 M4 : Fiche technique (7 pages), Note d'installation et d'entretien (46 pages), Manuel de démarrage rapide (2 pages), Manuel de démarrage rapide (5 pages)

Installing a Blade Server in the Chassis

Figure 5: Removing a Slot Divider

Tip

Step 2

Grasp the front of the blade module and place your other hand under the blade to support it.

Figure 6: Positioning a UCS B260 M4 Blade Module in the Chassis

Step 3

Open the ejector levers in the front of the blade module.

Step 4

Gently slide the blade into the blade slot opening until you cannot push it any farther.

Step 5

Press the ejector levers so that they latch with the edge of the chassis and press the blade module all the way

in.

Step 6

Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers will

prevent stripped or damaged captive screws.

Step 7

Attach the UCS Scalability Terminator or UCS Scalability Connector to the blade module(s) as follows:

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v3 and E7 v2 CPUs

To reinstall the slot divider, align it with the dimples in the slot top and bottom and slide it back

in until it clicks into place.

Installing a Blade Server