Cisco UCS E Series Manuel d'installation - Page 27

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Cisco UCS E Series. Cisco UCS E Series 46 pages. Ucs e series unified computing system
Également pour Cisco UCS E Series : Aperçu du produit (8 pages), Manuel de dépannage (28 pages)

Cisco UCS E Series Manuel d'installation
Push the module into place until you feel the module seat securely into the connector on the router
Step 3
backplane. The module faceplate should contact the chassis rear panel.
Tip
Step 4
Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module
faceplate.
Step 5
If you are installing a single-wide E-Series Server, install a blank faceplate on the other side of the slot.
See the
Connect the E-Series Server to the network and power up the router and E-Series Server.
Step 6
What to Do Next
1.
2.
3.

Verifying E-Series Server Installation

Before You Begin
To verify the E-Series Server installation, use one of the following commands:
OL-26447-03
When installing the E-Series Server into a Cisco ISR 4451-X, if the module does not completely
slide into the router, push the module slightly upwards, and then inward to complete the
insertion.
"Installing the Blank Faceplates" section on page
Load a compatible Cisco IOS image.
Power on the server.
Verify that the router recognizes the E-Series Server. See the
Installation" section on page
Install the E-Series Server into the router.
Load a compatible Cisco IOS image.
Power on the server.
To display a high-level overview of the entire physical system, use the show platform command:
Router# show platform
Chassis type: ISR4451/K9
Slot Type State Insert time (ago)
--------- ------------------- ---------------------
0 ISR4451/K9 ok 1d01h
0/0 ISR4400-4X1GE ok 1d01h
1 ISR4451/K9 ok 1d01h
1/0 UCS-E160DP-M1/K9 ok 1d01h
2 ISR4451/K9 ok 1d01h
R0 ISR4451/K9 ok, active 1d01h
F0 ISR4451/K9 ok, active 1d01h
P0 XXX-XXXX-XX ok 1d01h
P1 Unknown ps, 1d01h
P2 ACS-4450-FANASSY ok 1d01h
Slot CPLD Version Firmware Version
--------- ------------------- ---------------------
22.
27.
Hardware Installation Guide for Cisco UCS E-Series Servers
Installing the E-Series Servers
"Verifying E-Series Server
27