Epson Expression 636 Manuel d'installation facile - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel d'installation facile pour {nom_de_la_catégorie} Epson Expression 636. Epson Expression 636 21 pages. Product support bulletin(s)
Également pour Epson Expression 636 : Manuel de configuration (36 pages), Manuel d'information sur les produits (5 pages), Manuel du logiciel (4 pages), Manuel (11 pages), Bulletin d'information sur les produits (14 pages), Bulletin d'information sur les produits (5 pages)

Caution:

Make sure that the scanner, the computer, and any other SCSI

devices are turned off and unplugged from the power source.

1. Install the SCSI board in your computer, if necessary. Follow

the instructions that came with your SCSI board.

2. Connect the 50-pin end of the cable to either the top or

bottom SCSI connector of the scanner; then squeeze the wire

clips together until they lock in place on both sides.

3. Plug the 25-pin connector into the SCSI port on your

computer. Tighten the two screws on the sides of the

connector.

4. Plug in the power cables of your computer, scanner, and

other external SCSI devices.

5. Turn on your scanner, then your computer. (Always turn the

scanner on before the computer.)

Note:

If you are using Windows 3.1, you need to install the SCSI software

included with your SCSI adapter. See your SCSI adapter documentation

for instructions.

Installing the Scanner Software

Now that you have connected the scanner to your computer, the

next thing to do is install your scanner software. Instructions for

installing all of the software included with your scanner are in

this section. You do not need to install all the software, but you

do need to install the EPSON Scanning Utilities.

6 Installing the Scanner Software