Cisco 1100 Series Manuel d'installation du matériel - Page 37
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco 1100 Series. Cisco 1100 Series 44 pages. Terminal gateway
Également pour Cisco 1100 Series : Installation et mise à niveau (15 pages), Manuel (12 pages)
Imprimer la page
Install and Connect the Router
root@usb-suse# cd /dev
root@usb-suse /dev# ls -ltr *ACM*
crw-r--r--
root@usb-suse /dev#
Step 4
Connect to the USB port with the following command followed by the router USB port speed
Example:
root@usb-suse /dev# screen /dev/ttyACM0 9600
To disconnect the Linux USB console from the Terminal window
Enter Ctrl-a followed by : then quit
Connect WAN and LAN Interfaces
This section describes how to connect WAN and LAN interface cables. Before you connect the interface
cables, refer to the following warning statements:
Warning
For connections outside the building where the equipment is installed, the following ports must be connected
through an approved network termination unit with integral circuit protection: LAN, Ethernet. Statement
1044.
Ports and Cabling
This section summarizes typical WAN and LAN connections for Cisco 1100 Terminal Gateway Server.
Table 3: WAN and LAN Connections
Port or Connection
Ethernet
Gigabit Ethernet SFP,
optical
Gigabit Ethernet SFP,
copper
Supported cables for Async Ports
For asynchronous serial ports new Cable CAB-ASYNC-8 is supported.
1 root
root
188,
Port Type, Color
RJ-45, yellow
LC, color according to
optical wavelength
RJ-45
0 Jan 14 18:02 ttyACM0
Connection
Ethernet hub or Ethernet
switch
GLC-SX, -LX, -LH, -ZX,
-BX, -EX, -TE
1000BASE-T
Hardware Installation Guide for the Cisco 1100 Terminal Gateway
Connect WAN and LAN Interfaces
Cable
Category 5 or higher
Ethernet
Optical fiber as specified on
applicable data sheet
Category 5, 5e, 6 UTP
33