Cisco 1700 series Manuel de configuration - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel de configuration pour {nom_de_la_catégorie} Cisco 1700 series. Cisco 1700 series 25 pages. Secure firewall management center
Également pour Cisco 1700 series : Manuel de conformité réglementaire et d'information sur la sécurité (45 pages), Manuel (15 pages), Note d'application (41 pages), Dépannage du matériel (12 pages), Manuel de synthèse (13 pages), Configuration (34 pages), Manuel (5 pages), Manuel de démarrage rapide (6 pages), Manuel d'installation du matériel (46 pages)

Imprimer la page
Cisco 1700 series Manuel de configuration
IOS Commands
Related Commands
half-duplex Command
To put the Ethernet interface into half-duplex mode, use the half-duplex command.
Syntax Description
half-duplex
Default
Half-duplex mode
Command Mode
Interface configuration mode
Usage Guidelines
Use the half-duplex command to put the Cisco WIC-1ENET Ethernet interface into 10 Mbps
half-duplex operation, the default state of the Ethernet interface.
Example
The following example puts the Ethernet interface into half-duplex mode of operation.
1750(config)#interface Ethernet 0
1750(config-if)#half-duplex
To verify the interface state, enter a show interface command as follows:
1750#show interface Ethernet 0
Ethernet0 is up, line protocol is up
Hardware is PQUICC Ethernet, address is 0001.64ff.ef6a (bia 0001.64ff.ef6a)
MTU 1500 bytes, BW 10000 Kbit, DLY 1000 usec,
Encapsulation ARPA, loopback not set
Keepalive set (10 sec)
Half-duplex, 10BaseT
....
Related Commands
half-duplex Command
4
half-duplex
half-duplex
Interface is in half-duplex mode.
reliability 255/255, txload 1/255, rxload 1/255
full-duplex
no full-duplex
78-11422-03