b4Adventure Slackers NINJA SWING LINE DELUXE Manuel - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} b4Adventure Slackers NINJA SWING LINE DELUXE. b4Adventure Slackers NINJA SWING LINE DELUXE 8 pages.
Imprimer la page
NINJA GRIP CLIPS: Your set may include additional clips that can be used to extend the play area on the
NINJALINE™ by adding more obstacles on the ends of the line, outside of where pockets are sewn. See below for
instructions on how to attach your obstacles using the Ninja Grip Clips.
STEP 1
Start by feeding the
line through the top
opening of the clip
*Note: The Delta carabiner should be centered between the 2 divits on the inside of the clip
NINJALINE™ SET UP
• Make sure the SLACKERS logo is FACE UP. Feed the line thorugh the line protectors (Figure 1) and slide down
to the end of each line (Figure 2).
• Take Ratchet Line: wrap around tree and tighten (Figure 3). TIP: to keep you line flat, pinch the line to form a
U-shape section where it feeds through the looped end (Figure 4).
• Take Slackline walking line and wrap around the opposite tree and tighten keeping line flat and not twisted.
Figure 1
TIGHTENING THE NINJALINE™
• The ratchet will only take up about 1 ft of line. You must pull the line tight before using the ratchet. Be sure that
the line is not twisted prior to using the ratchet to tension the line.
Pull the release
lever to open the
ratchet. (open slot
on axle should be
facing up).
b4Adventure • Denver Colorado 80216 • 1-844-834-4334 • [email protected]
STEP 2
Make sure the line is flat
inside the clip, with the open-
ing facing upward
Figure 2
Thread the strap
through the bottom of
the ratchet. The
ratchet handle should
be on top so you can
move it to tighten.
www.b4adventure.com - DC:081320
STEP 3
Pull the line through the
bottom of the clip to create
a U shape
Figure 3
Pull the line
through until the
line is tight
STEP 4
Insert the Delta carabiner
into the U shape and pull
the line outside the clip taut.
Figure 4
Crank the ratchet to
tension the line. Once
line is taught, secure the
ratchet by closing it
completely and slide the
ratchet cover over the
ratchet and excess line
4