Digitus professional DS-55100-1 Manuel - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Digitus professional DS-55100-1. Digitus professional DS-55100-1 8 pages. Hdmi extender set, full hd

Imprimer la page

[NOTE] It is recommended to use a length range within 15~50m

network cable. If the CAT6 cable is too short, there may be no display

output because of the signal is too strong. If the CAT6 cable is too

long,the output may be with poor quality.

4. IR User Guide

4.1 IR blaster extension cable should plug in the IR OUT port of

TX(Sender) of HDMI extender, and the IR receiver extension cable

should plug in the IR IN port of the RX (receiver) unit.

4.2 The emitter of IR blaster should as close as possible to the IR

receiver window of the signal source device.

4.3 Using the IR remote controller of the signal source device towards

the IR receiver (connected to the RX), to remote control source

media playback.

5. EDID Setting

5.1 First of all, set the resolution mode of the source device; please

choose "AUTO" of theresolution mode. (However, when the

resolution mode of your source device is"AUTO" already, and the

output resolution (for instance, output is 720p) is still not in accord

with the resolution that set by the EDID dip switch (for instance, it is

1080p). At this time, please set the resolution of your device again to

make it in accord with the resolution that set by the EDID dipSwitch

(e.g. 1080p)

5.2 HDMI source device reads the EDID information of the transmitter (TX)

and then output the Relative HDMI signal forma

5.3 It needs to power on again or reset the transmitter unit after

re-setting EDID every time

5.4 When connect a TV with loop-out HDMI port of transmitter (TX), it

can adjust EDID switch to read and save this TV's EDID information.

When we use this function, it should connect TV with transmitter

first, and then power on these devices, so that the EDID will be read

and saved successfully. At next time, even though do not connect a

TV into the loop-out HDMIPort, the source device will output the

saved EDID information last time.