Acuity Brands 00194995254316 Manuel de démarrage rapide - Page 9

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Acuity Brands 00194995254316. Acuity Brands 00194995254316 10 pages.

Imprimer la page
If this fixture fails to operate properly, use the guide below to diagnose and correct the problem.
SYMPTOM
Lights will not come on
Lights come on during the
day.
Lights come on for no
apparent reason
Lights stay on continuously 1.
Lights flash on and off
(strobing)
Range appears limited
Lights will not trigger with
motion
If further technical assistance is required, contact: Technical Support at: (800) 705-7378
This LED light provides low maintenance service with no bulbs to change. Clean surfaces with mild soap
and water. Do not use abrasive materials such as scouring pads or powders, steel wool or abrasive paper.
WARNING: There are no user serviceable parts inside fixture.
Contractor Resources
Check out helpful programs, tools, installation videos and more!
POSSIBLE CAUSE
1.
Light switch is turned off.
2.
Fuse is blown or circuit breaker is turned off.
3.
Incorrect circuit wiring.
4.
Motion is not detected.
5.
Photocontrol does not work.
1.
Light fixture/Sensor may be located in a
relatively dark location.
2.
Motion Sensor is in TEST mode.
1.
Motion sensor maybe detecting movement
from small animals or passing cars.
2.
Sensitivity set too high.
3.
The outdoor temperature is getting cooler.
4.
The light fixture is wired through a dimmer
or timer.
Motion Sensor is in Manual Override mode.
2.
The sensor may be picking up a heat
source like an air vent, dryer vent, or brightly
painted, heat-reflective surface.
3.
The sensor may be picking up motion due
to gusty wind
1.
Heat or light from the lamps may be turning
the light control on and off.
2.
Heat being reflected from other objects may
be affecting the sensor.
3.
Sensor is in Test mode.
1.
Sensor is not level.
2.
Sensor is mounted too high or low.
3.
Movement is directly towards sensor.
1.
Sensitivity may be set too low.
TROUBLE SHOOTING GUIDE
SOLUTION
1.
Turn light switch on.
2.
Replace fuse or turn circuit breaker on.
3.
Verify wiring is correct. Check wire connections.
4.
Turn MOTION sensor dial to higher sensitivity.
5.
Test photocontrol function (cover daylight
sensor, light should come on)
1.
Fixture is operating normally under these
conditions. Turn Daylight sensor dial to higher
sensitivity.
2.
Set MODE dial to M1 or M5 position.
1/2/3. Reduce Motion sensitivity
4. Do NOT use a dimmer or timer to control light
fixture.
1.
Follow manual override instructions to reset.
2.
Reduce sensitivity.
1.
Reposition the lamp heads so Light is not
reflected toward the Daylight sensor.
2.
Reduce Sensitivity.
3.
While in TEST mode, light only stays on for 5
seconds.
1.
Position sensor exactly level from side to side
2.
If mounted above 20 feet, much of the usable
range will be lost. Mount at 6 to 10 feet for max.
range.
3.
Move Sensor. Sensor will see movement across
detection pattern more quickly. Move sensor in
¼" increments.
1.
Turn up sensitivity in small steps
Acuity Brands Lighting, Inc.
One Lithonia Way, Conyers, GA 30012
www.AcuityBrands.com