Cisco VG204XM Manuel d'installation du matériel - Page 44
Parcourez en ligne ou téléchargez le pdf Manuel d'installation du matériel pour {nom_de_la_catégorie} Cisco VG204XM. Cisco VG204XM 48 pages. Voice gateways
Également pour Cisco VG204XM : Manuel de démarrage rapide (19 pages)
Imprimer la page
Performing the Initial Configuration
Continue with configuration dialog? [yes/no]:
You are now in the setup command facility.
The prompts in the setup command vary, depending on your voice gateway model, on the installed
interface modules, and on the software image. The following steps and the user entries (in bold) are
shown as examples only.
Note
To proceed using the setup command, enter yes:
Step 2
Continue with configuration dialog? [yes/no]: yes
When the following messages appear, enter yes to enter basic management setup:
Step 3
At any point you may enter a question mark '?' for help.
Use ctrl-c to abort configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity
for management of the system, extended setup will ask you
to configure each interface on the system
Would you like to enter basic management setup? [yes/no]: yes
Step 4
Enter a hostname for the voice gateway.
Configuring global parameters:
Enter host name [VG]: VG
Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when
Step 5
viewing the configuration.
The enable secret is a password used to protect access to
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: xxxxxx
Step 6
Enter an enable password that is different from the enable secret password. This password is not
encrypted (less secure) and can be seen when viewing the configuration.
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
Enter enable password: xxxxxx
Enter the virtual terminal password, which prevents unauthenticated access to the voice gateway through
Step 7
ports other than the console port:
The virtual terminal password is used to protect
access to the voice gateway over a network interface.
Enter virtual terminal password: xxxxxx
Respond to the following prompt as appropriate for your network:
Step 8
Configure SNMP Network Management? [yes]:
Community string [public]:
Cisco VG202, Cisco VG202XM, Cisco VG204, and Cisco VG204XM Voice Gateways Hardware Installation Guide
4-4
If you make a mistake while using the setup command facility, you can exit and run the setup
command facility again. Press Ctrl-C, and enter the setup command at the privileged EXEC
mode prompt (VG#).
Chapter 4
Powering On the Voice Gateway and Performing the Initial Configuration
OL-15959-01