Epson ProofPlus TM-H6000III Manuel de l'utilisateur - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Epson ProofPlus TM-H6000III. Epson ProofPlus TM-H6000III 32 pages. Ecc printer
Également pour Epson ProofPlus TM-H6000III : Manuel du produit (27 pages), Brochure (2 pages), Spécifications (2 pages), Brochure (6 pages), Manuel de développement (26 pages), Manuel de développement (45 pages), Manuel de développement (32 pages), Manuel (10 pages), Manuel de l'utilisateur (29 pages)

Imprimer la page
Epson ProofPlus TM-H6000III Manuel de l'utilisateur
2.
The printer will detect the check and start drawing it in. When the printer
starts drawing it in, let go of the check immediately. When the printer ejects
the check and the SLIP LED starts flashing again; remove the check by pulling
it straight up; do not pull it at an angle.

Cleaning the MICR Mechanism

Approximately every 12 months clean the MICR head with a moistened cleaning
sheet.
Use the following or an equivalent commercially available cleaning sheet:
PRESAT brand (KIC) "CHECK READER CLEANING CARD."
Note:
Be sure not to use an adhesive cleaning sheet.
Follow the steps below:
1.
Load a paper roll in the printer; turn off the power; then open the paper roll
cover and turn the power back on while holding down the RELEASE button.
2.
Press the RELEASE button 7 times; then close the paper roll cover. The printer
prints the following message on receipt paper and the SLIP LED flashes.
3.
Insert the cleaning sheet like a standard check.
CAUTION:
Be sure that the sheet is inserted with the correct side up and that it is inserted in
the correct direction.
Use a cleaning sheet only one time; then discard it.
When the sheet is ejected, press the RELEASE button, and remove the sheet
4.
from the printer.
Notes on using the MICR reader
Do not install the printer near any magnetic fields. Be especially careful where you
install your display device and be sure to check the recognition rate of the MICR
reader with the display device in place.
Make sure that the printer is not subjected to any impact or vibration when it is
performing a MICR reading.
TM-H6000III User's Manual 9
English