Acuity Brands NaviLite N1L Instructions d'installation - Page 2
Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Acuity Brands NaviLite N1L. Acuity Brands NaviLite N1L 3 pages. For led emergency lighting fixture
Imprimer la pageFOR LED EMERGENCY LIGHTING FIXTURE
IMPORTANT: Let the battery charge up
for at least 24 hours. Then normal
operation of this unit should take effect.
To check, press the "TEST" button. The
LED lamps on the unit should turn ON.
During an electrical power failure, the led
lamps will automatically come on for a
minimum of 90 minutes. In accordance
with NFPA 101, your emergency lighting
system must be tested monthly for a
minimum of 30 seconds and annually for
90 minutes. Refer to your local codes for
any additional requirements that may
apply.
USE FLEXIBLE CONDUIT ONLY.
©2016 Acuity Brands Lighting, Inc. Printed in the USA Rev 8/2017
INSTALLATION INSTRUCTIONS
INSTALLATION
J-BOX MOUNTING
1. Feed fixture leads through the
back plate and connect to AC
power supply (Fig A). For 120V
use black and white wires and for
277V, use red and white wires.
2. Attach back plate to J-Box and
secure with screws.
3. Complete the battery connection.
(Fig. B)
4. Align snaps and push housing
directly onto the back plate (Fig.
C). Apply continuous AC power
and press "TEST" button to check
light.
FIG. A
One Lithonia Way, Conyers GA 30012
FIG. C
Phone: 800-334-8694
P3508
pg 2 of 3
CONDUIT
1. Secure back plate to wall surface.
Route wires through hole in
conduit flange and make conduit
connection. For 120V, use black
and white wires and for 277V, use
red and white wires.
2. Complete the battery connection
(Fig. B).
3. Align snaps and push housing
directly onto the back plate (Fig.
C). Apply continuous AC power
and press "TEST" button to check
light.
WARNING: Unused wires must be
capped using enclosed wire nuts.
FIG. B