DigiWeight DWP-102E Manuel de l'utilisateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DigiWeight DWP-102E. DigiWeight DWP-102E 10 pages. Floor / pallet scale
Imprimer la pagec. Screw each foot onto the load cell at each corner of the scale base.
d. Take out the indicator from Box 2. Plug the scale serial cable into the socket on the back of the
indicator. And use a screw driver to tighten the two screws of the plug.
e. Plug in power to recharge the battery for 20 hours (recommended).
Turn on the indicator by pressing the ON/OFF button on the front of the indicator.
Now your scale is ready to use. For advanced operations, please refer to the following pages.
2.2 KEY FUNCTIONS
[UNIT]
Switch between weighing units.
[FUN]
Select or enter the function and save the setting values of parameters.
In counting mode, press to view unit weight, counts and total weight when "F3 Key"=1.
In the accumulation mode, press to view numbers when "F3 Key"=2.
Press to enter/exit animal mode when "F3 key"=5
Enter/exit counting mode when in weighing mode when "F3 Key"=1.
[MOD]
Accumulate and print when "F3 Key"=2.
Hold/release the readout when "F3 Key"=3.
Enter pre-tare value when "F3 Key"=4.
Parameter setting for animal weighing when "F3 Key"=5
[TARE]
Enter fast calibration when pressed in warming up.
Tare off the container weight.
When setting parameters press to change the value.
[ZERO]
Press to enter parameter setting during warming up.
Zero the readout
When setting parameters, press to move the cursor.
[ON/OFF]
Turn on/off the scale.
Floor / Pallet Scale
- 4 -