Acuity Brands Lighting Lithonia Lighting CSXW LED Manuel d'instructions - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} Acuity Brands Lighting Lithonia Lighting CSXW LED. Acuity Brands Lighting Lithonia Lighting CSXW LED 6 pages.

Imprimer la page

Installation Instructions

CSXW LED

DELIVERY: Upon receipt of fixture and accessories (packed separately), thoroughly inspect for any freight damage. All damage should be re-

ported to the delivery carrier. Compare the catalog description listed on the packing slip with the fixture label on the inside of the housing to

be sure you have received the correct merchandise.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause

harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

THIS FIXTURE MAY NOT BE INVERTED

Tools Required: #2 philips type and flathead screwdriver. 1/8" and 3/16" allen wrench.

CAUTION: APPLY A CONTINUOUS BEAD OF WEATHER - PROOF CAULKING BETWEEN MOUNTING PLATE AND WALL TO ENSURE WEATHER - TIGHT

INTEGRITY OF ELECTRICAL COMPONENTS.

This is an electronic device and should not be left exposed to the elements during storage, transportation or installation. It is rated for out-

door use once properly installed and in normal orientation.

Wall mounting plate

Integral support rods

figure 1

figure 2b

figure 2a

1. These steps below are for mounting over a standard recessed

junction box. Position mounting plate over j-box. The mounting

plate may be attached to the j-box for alignment only, it should not

be relied upon for structural support. Ensure integral support rod on

mounting plate is in a downward position and bubble level is at the

top.

Level mounting plate prior to tightening using integral bubble level.

Secure to wall using (4) 1/4" diameter fasteners (not provided). See

figure 1.

2. With the doorframe facing up, locate the 2 set screws (figure 2a).

Loosen the (2) set screws with 1/4"-20 x 1/2" hex socket so that they

are flush with the black finned plate (figure 2b).

5 year limited warranty

Mounting Detail

Part Number: RJ521346 Rev C

Revision Date: 5-30-17