Control Panel Buttons and Lights
Button/Light
Function
1
Font button
Selects one of the fonts.
Font lights
Indicate which font is selected.
2
Reset
When you press both the Font and Pitch
buttons simultaneously, the printer clears the
buffer and restores its default settings.
3
Pitch button
Selects one of the pitch settings.
Pitch lights
Indicates which pitch is selected.
4
Tear Off/Bin
Feeds continuous paper forward to the
button
tear-off position.
Feeds continuous paper backward from the
tear-off position to the top-of-form position.
Selects a cut-sheet feeder bin when the
cut-sheet feeder is installed.
Tear Off/Bin
Flashes when continuous paper is in the
light
tear-off position.
On when bin 1 of the optional cut-sheet
feeder is selected.
Off when bin 2 of the optional cut-sheet
feeder is selected.
5
LF/FF button
Feeds paper line by line when pressed quickly.
Ejects a single sheet or advances continuous
paper to the next top-of-form position when
held down.
6
Micro Adjust
When you hold down the Pause button for
three seconds, the printer enters Micro Adjust
mode. In this mode, you can press the LF/FF
D and Load/Eject U buttons to adjust the
top-of-form or tear-off position.
7
Load/Eject
Loads a single sheet of paper.
button
Ejects a single sheet of paper.
Loads continuous paper from the standby
position.
Feeds continuous paper backward to the
standby position if a sheet is loaded.
8
Pause light
On when the printer is paused.
Flashes when the printer is in Micro Adjust
mode.
9
Pause button
10
Lock
11
Paper Out light
Power-on Functions
The table below summarizes the power-on functions available
through the control panel. To perform the function on the
right, hold down the button(s) on the left while you turn on the
printer.
Control panel button
Load/Eject
LF/FF
Font
Load/Eject + LF/FF
Load/Eject + LF/FF + Pause
Pause
Load/Eject + Pause
LF/FF + Pause
Font + Pitch
Pitch + Pause
Font + Tear Off/Bin
Tear Off/Bin + Pause
10/01
EPSON FX-880+/FX-1180+
Stops printing temporarily, and resumes
printing when pressed again.
When held down for three seconds, enters
Micro Adjust mode. When pressed again,
exits Micro Adjust mode.
When Lock-out mode is on, the Paper Out and
Pause lights flash if a locked button is
pressed.
On when no paper is loaded in the selected
paper source or paper is not loaded correctly.
Flashes when paper has not been fully ejected
or a paper jam has occurred.
Function
NLQ self test
Draft self test
Default setting mode
Data dump
EEPROM reset
Bidirectional adjustment mode
Control panel Lock-out mode (on/off)
Default settings for control panel
Lock-out mode
Quiet mode
Copy mode
Default setting, simple mode
Okidata ML 320T mode (FX-880+ only)
EPSON FX-880+/FX-1180+
7
-
Imprimer la page