Epson FX-880+ Manuel rapide - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel rapide pour {nom_de_la_catégorie} Epson FX-880+. Epson FX-880+ 33 pages. Epson serial impact dot matrix printers
Également pour Epson FX-880+ : Manuel de configuration (33 pages), Brochure & Specs (24 pages), Manuel (18 pages), Spécifications (2 pages), Lisez d'abord ceci (2 pages), Manuel de référence (34 pages)

4. Slide the left sprocket approximately 12

mm (0.5 inch) from the far left position

and push the lever back to lock it in

place. Then slide the right sprocket to

match the width of your paper, but do

not lock it. Move the center support

midway between the two sprocket units.

* approx. 12 mm (0.5 inch)

5. Make sure your paper has a clean,

straight edge. Then open the sprocket

covers.

Note:

Make sure the printer is off before you insert

the paper in the paper slot. If you insert the

paper while it is on, a paper jam may occur.

6. Insert the paper into the front or bottom

paper slot as shown in the illustration

below until it emerges between the

platen and the ribbon guide. Then pull

up the paper until the perforation

between the first and second pages is

even with the top of the printer's ribbon.

Downloaded from:

http://www.usersmanualguide.com/

EPSON FX-880+/FX-1180+ Quick Guide

Front slot

Before you load paper in the front slot,

remove the front cover.

Then load paper with the printable side

facing up.

Bottom slot

Load paper in the bottom slot with the

printable side facing up.

Continuous Paper with the Pull Tractor (2/4)