TomTom Bandit Manuel de référence - Page 21

Parcourez en ligne ou téléchargez le pdf Manuel de référence pour {nom_de_la_catégorie} TomTom Bandit. TomTom Bandit 44 pages.

Switching on and off

Your Bandit can be on, off, or in standby. You can only switch the camera on and off using the

buttons on the camera.

Switching on your Bandit

Press the START button (button 2) at the back of the camera for 2 seconds to switch your camera

on. If no SD card is inserted into the battery stick, you are asked to insert one so that the camera

can switch on.

The camera stays during any of the following:

1. The camera is recording a video or you are taking photos.

2. You are using the screen to set-up the camera.

3. You are operating the camera from your mobile phone using Wi-Fi or Bluetooth.

Switching off your Bandit

Press the STOP button (button 1) at the front of the camera for 2 seconds to switch off the camera.

The camera can also be off during any of the following:

1. No battery is installed in the camera.

2. The battery is empty. If the camera is in on or in standby mode, it switches itself off if the

battery level gets too low.

Standby

To save power the camera automatically switches to standby after a few minutes if it's not being

used. You can wake up the camera by pressing the control button (button 5) or by using Bluetooth

to connect to the camera from your smartphone.

To reset your camera, do the following:

From the Camera Status screen on your camera, move down to open the SETTINGS screen. Select

GENERAL then select OPTIONS.

Select RESET to choose from two reset options:



RESET ALL - resets your camera to the factory settings and restarts the camera.

Note: A reset does not delete your photos and videos stored on the memory card.

RESET WIFI - resets your Wi-Fi password.

