Epson LQ-1170 Bulletin d'information sur les produits - Page 10

Parcourez en ligne ou téléchargez le pdf Bulletin d'information sur les produits pour {nom_de_la_catégorie} Epson LQ-1170. Epson LQ-1170 20 pages. Understanding and using escp/3 commands and syntax
Également pour Epson LQ-1170 : Manuel (5 pages), Bulletin d'information sur les produits (20 pages), Bulletin d'information sur les produits (5 pages), Fiche technique (7 pages), Manuel d'installation (1 pages), Manuel d'assemblage (8 pages), Bulletin d'information sur les produits (16 pages)

ESC ( t n1 n2 d1 d2 d3 (Assign Character Table)

ESC ( t n1 n2 d1 d2 d3 is the command for assigning character tables where nl, n2,

selectable with the ESC t n command. This is the table that will be replaced. Valid

corresponding to a registered table. lhii is the table that will replace the table

indicated by Variable dl. Valid Values for d2 are 0, 1,3,7,8, and 9 (see Table 2

0 -1 Italic

Table 1

After using the ESC ( t command, the ESC t n command MUST be sent to select the

table before printing from the new table. For example, the command ESC ( t 3 0 1 3

0 is sent (assign Registered Table 3 (PC950) to Selectable Table 1 (PC437). In order

to print the Q character (ASCII 245), the command ESC t 1 must be sent. In the Basic

programming language, the sequence would be as follows:

LPRINT CHR$(27);7';CHR$(l);

LPRINT CHR$(245)

Some ESC/P2 documentation may illustrate as many as 22 different Registered

Tables. The Registered Tables are a part of the character set, therefore, they are

contained in the Character Generator ROM. The CG ROM differs based upon the

destination country. For this reason, only the above Registered Tables are available

on LQ-570, LQ-1070, LQ-870 and LQ-1170 printers sold for the U.S. market. Foreign

Character Generator ROMs ARE NOT available in the United States. The following

PSB No: P-0082

Page:

I I 9 I