Epson Stylus Color 880i Manuel de l'utilisateur - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Epson Stylus Color 880i. Epson Stylus Color 880i 13 pages. Windows printer software does not install
Également pour Epson Stylus Color 880i : Fiche technique (2 pages), Fiche d'information sur le produit (4 pages), Commencer ici (4 pages), Brochure (2 pages), Manuel de dépannage (1 pages)
Imprimer la page
Removing and Installing Ink Cartridges
You can replace a cartridge when the B black or A color ink
out light is either flashing or on. (If you perform these steps
when both ink out lights are off, the printer cleans the print
heads as described on page 9.)
Be sure you have a new ink cartridge before you begin. Once
you start the ink cartridge replacement procedure, you must
complete all the steps in one session.
Follow these steps to replace ink cartridges:
1. Make sure the printer is turned on and not printing (the
Ppower light should be on, but not flashing), then open
the printer cover.
2. Press the A cleaning button and hold it for about three
seconds until the print head moves left and the Ppower
light begins flashing.
To avoid damaging the printer, never move the print head
by hand. Don't open the clamp or remove a cartridge
except to replace it with a new one. Once you remove a
cartridge, you can't reuse it, even if it contains ink.
3. Pull up the ink cartridge clamp. The cartridge rises up from
its holder. (The illustration shows color ink cartridge
replacement. To replace the black ink cartridge, lift up only
the smaller clamp on the left.)
4. Lift the cartridge out of the printer and dispose of it
carefully.
Keep ink cartridges out of the reach of children and don't
drink the ink.
If ink gets on your hands, wash them thoroughly with
soap and water. If ink gets into your eyes, flush them
immediately with water.
5. Unwrap the new ink cartridge. Then remove only the yellow
part of the tape seal on top.
black cartridge
You must remove the yellow tape from the top of the
cartridge or you will permanently damage it. Don't try to
remove the clear seal underneath the cartridge.
6. Tilt the new cartridge forward slightly as you lower it into
its holder. Hang the tabs at the back of the cartridge on the
hooks.
Don't place the cartridges under
the hooks; you may damage the
clamp when you close it.
7. Press down the ink cartridge clamp until it locks in place,
but don't press down on the cartridge itself.
8. If you need to replace the other ink cartridge, repeat steps 3
through 7 before continuing with step 9.
8/00
EPSON Stylus Color 880/880i
color cartridge
EPSON Stylus Color 880/880i
- 7