Epson Stylus Photo R290 Manuel d'instruction - Page 4
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Epson Stylus Photo R290. Epson Stylus Photo R290 4 pages. Epson stylus photo r290: product brochure
Également pour Epson Stylus Photo R290 : Spécifications (1 pages), Spécifications (2 pages), Commencer ici (4 pages)
Imprimer la page
Thank you for purchasing the Continuous Ink System: We hope you found this manual useful.
If the ink tank is full of ink computer shows a message
"Replace
Cartridge", That the cartridges are empty.
1
The printer keeps track of how much ink is being used
and thinks that the cartridge should be empty so you will
have to reset the cartridges chips.
2
Banding or white lines in my print outs.
3 When I have completed a printing job the ink is
siphoning backwards down the tubing.
The tubing is getting caught inside the printer resulting
4
in an error message"paper loading error".
5 After refilling the tanks the printer won't print.
After installing the CI system the printer isn't
6
recognizing some of the cartridges.
Problem
If you are still unable to fix the problem call your dealer for support.
Troubleshooting tips
Please refer to the reset procedure.
Step 8.
There is air in the system or cartridges. Try running a couple of
cleaning cycles. If white lines continue use the provided
syringe to suck the air out of the bottom of the trouble cartridge
and you can dump the ink that fills the syringe back into the top
of the CI system. (Make sure to thoroughly rinse the syringe
when completed.)
The shipping plugs need to be removed before installing and
replaced with the air breathers to eliminate any pressure being
built up in the system, along with protecting the ink from
contamination. Also the ink tank should be sitting on the same
level surface as the CI system. If the air breathers are covered
with dried ink, you can rinse the air breather and dry
thoroughly to regain use.
If the tubing is not adjusted correctly, if it's to short or to long
causing it to slap the inside of the printer, Please adjust.
If the ink is dumped into the system to quickly then it allows
air to enter the system. Use the provide syringe to extract ink
and air from the bottom of the cartridges. The ink that fills the
syringe can be slowly dumped back into the top of the ink tank.
Remove the cartridges, turn off the printer and reinstall the
cartridges. Then you can continue printing.
Suggestion
2008-8-14 13:38 PM