Epson Stylus Photo R390 Manuel de l'utilisateur - Page 28
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Epson Stylus Photo R390. Epson Stylus Photo R390 36 pages.
Également pour Epson Stylus Photo R390 : Commencer ici (1 pages), Liste des pièces Manuel (8 pages)
Imprimer la page
6.
Look at the alignment pattern in each set and find
the patch which is most evenly printed, with no
noticeable streaks or lines.
7.
Press the r button, then press the u or d button to
highlight the number for the best pattern (1 to 9)
in set #1, then press the OK button.
8.
Repeat step 7 to select the best pattern for sets #2,
#3, and #4.
9.
When you have finished, press the OK button.
Cleaning the Printer
Cleaning the outer case of the
printer
To keep your printer working at its best, you should
clean it several times a year. Follow these steps:
1.
Turn off the printer, unplug the power cord, and
disconnect the printer cable.
2.
Remove all paper, then use a soft brush to clean
any dust or dirt from the sheet feeder.
3.
Clean the exterior of the printer with a soft, damp
cloth.
4.
Use a soft, dry cloth to clean the LCD screen. Do
not use liquid or chemical cleaners on the LCD
screen.
5.
If ink has spilled inside the printer, wipe it off only
in the area shown below using a soft, damp cloth.
Clean here
w
Warning:
Do not touch the gears inside the printer.
c
Caution:
❏ Be careful not to wipe away lubricating grease inside the printer.
❏ Never use a hard or abrasive brush, or alcohol or thinner for
cleaning; they can damage the printer components and case.
❏ Do not get water on the printer components and do not spray
lubricants or oils inside the printer.
❏ Do not apply grease to the metal parts under the print head
carriage.
28
Maintenance and Transporting
Cleaning the roller inside the printer
To keep your printouts at their best, feed paper and
clean the roller inside by using the Load/Eject Paper
function.
1.
Load several sheets of A4 size paper.
2.
Press the F [Setup] button, press the l or r button
to highlight Maintenance, then press the OK
button.
3.
Press the u or d button to select Load/Eject
Paper, then press the OK button. Then press the
Start button.
4.
Repeat Step 3 if needed.