Dillon Precision Products RL 550B Manuel d'instruction - Page 11

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Dillon Precision Products RL 550B. Dillon Precision Products RL 550B 18 pages.

Imprimer la page

Fig. 16 - A fully loaded shellplate, directly below the

proper dies. Clockwise from Station One, the cartridge at

this station is resized, deprimed and reprimed. Notice the

cartridge retaining spring holding the case in place.

Station Two bells the case mouth (pistol only) and

dispenses the powder. Station Three seats the bullet.

Station Four crimps the bullet.

Station One

In the first station, Fig. 16, brass is resized,

deprimed, and then reprimed.

Using the die lock rings provided, screw the sizing

die into the toolhead. Raise the platform and screw the

die down until it touches the shellplate. Then back it

off one-half turn. Lower the platform and insert an

empty case into Station One and cycle the operating

handle. Now check it for sizing and depriming.

If it looks good, raise the platform so the case is in

the die, tighten the lock ring on the die and tighten the

decapping stem. This will keep everything centered.

A note of caution, never attempt to deprime a live

primer. An explosion may result.

Station Two

In the second station, the powder is dropped and

the mouth of the case is belled. This is where the

Automatic Powder System is installed.

Fig. 17 - This photo shows the powder die in its correct

position (Station Two) in the toolhead. The powder die

may be higher or lower depending on the caliber it is being

adjusted for

Fig. 18 - Drop the powder funnel into the powder die

tapered end first. The funnel should move freely in the die.

First, screw the powder die (#20064) into the

toolhead, Fig. 17. Now insert the pistol powder funnel

(*#13782) or a rifle powder funnel (*#13426) with the

tapered end down, Fig. 18. The funnel should move

freely in the die.

Fig. 19 - The powder die can be easily adjusted by turning

the die beneath the toolhead while holding the powder

measure securely from above.

Set the powder measure assembly onto the powder

die, Fig. 19. The powder measure clamp (#13939)

should fit loosely around the die, tighten the screws

just a little. This will enable you make adjustments to

the die easily, Fig. 19.

* Indicates a caliber specific part. See the caliber conversion

chart on page 16 for the caliber you are loading for.