Epson TM-H6000II Manuel - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Epson TM-H6000II. Epson TM-H6000II 13 pages. How to connect printer with a wireless adapter
Également pour Epson TM-H6000II : Brochure (2 pages), Brochure (2 pages), Manuel de l'utilisateur (15 pages), Manuel d'instructions (12 pages)

Imprimer la page

How to connect an Epson POS printer with Ethernet Interface

(Key: 2-7 On: refers to the switch number 7 is turned On)

Confirm the initial settings of the Printer

Run the printer self test (hold down the feed button while turning on the printer). The printer will print a list of initial settings

including interface type and buffer capacity. Verify that the interface is "serial" for this type of Ethernet adapter.

Quick Test Printout, Type II Adapter

To get a configuration / status report with information about the printer and Ethernet module, along with maintenance

counts and settings, do the following:

for PRINTERS with Cover Sensor

Power the Printer up, with Ethernet Module installed .

Pop the receipt printer cover

Press the FEED button

Close the receipt printer cover

NOTE:

printout will indicate an UNKNOWN PRINTER. If this happens, cycle power, and wait for the Green LED to

start blinking. - With the module connected to a Ethernet, this delay will be shorter than if there is no

Ethernet connected and the modules spends longer looking for one.

for PRINTERS without Cover Sensor

With a powered OFF module

Set Dip-Switch 1 (on the module) to ON

Power up the unit

Status Report will print

http://www.beaglehardware.com/howtoethernet.html[3/4/2011 12:27:20 PM]

Wait for the green LED on the module to start blinking! If you proceed with this too quickly, the

Printer

Sale!

TM-U220

$129

TM-U295

$184

TM-U375

$199

TM-

U675

$199

TM-

H6000III

$349

TM-T88II

$109

TM-T88III

$139

TM-T88IV

$199

TM-T88V

$259

New

TM-U200

$99