Motorola CLP107e Manuel de l'utilisateur - Page 36
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Motorola CLP107e. Motorola CLP107e 42 pages.
Imprimer la page
MN007419A01-AA
Chapter 7: Troubleshooting
If...
Message not transmitted or received
Heavy static or interference
Low batteries
Drop-in Charger LED light does not blink
Battery does not charge although it has
been placed in the drop-in charger for a
while
36
Then...
ings. Increasing power provides greater
signal range and increased penetration
through obstructions.
Perform one of the following actions:
•
Ensure the PTT button is completely
pressed when transmitting.
•
Confirm that the radios have the same
Channel, Frequency, Interference
Eliminator Code, and Scramble Code
settings. See
Transmitting and Receiving
on page
16.
•
Recharge, replace, or reposition batter-
ies. See
Battery Specifications on page
22.
•
Change the radio placement. Obstruc-
tions and operating indoors, or in vehi-
cles, may interfere.
•
Verify that the radio is not in Scan mode.
See
Scanning Radio Channels on page
20.
Radios are too close. Ensure the transmit-
ting and receiving radios are at least 5 ft (1.5
m) apart.
Radios are too far apart or obstacles are in-
terfering with transmission.
Recharge or replace Li-Ion battery.
NOTICE: Extreme operating tem-
peratures affect battery life.
See
Battery Specifications on page
Perform one of the following actions:
•
Verify that the radio and battery is prop-
erly inserted.
•
Check the battery and charger contacts
to ensure that they are clean and charg-
ing pin is inserted correctly.
See
Charging a Stand-Alone Battery with
the Drop-in Tray SUC on page 24
Charger LED Indications on page
Perform one of the following actions:
•
Verify the drop-in tray charger is properly
connected and corresponds to a compat-
ible power supply. See
Stand-Alone Battery with the Drop-in
Tray SUC on page
24.
22.
and
26.
Charging a