Motorola EASE44CONNECT Manuel de l'utilisateur - Page 28

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Motorola EASE44CONNECT. Motorola EASE44CONNECT 38 pages. 4.3" wi-fi video baby monitor
Également pour Motorola EASE44CONNECT : Manuel de l'utilisateur (44 pages)

Motorola EASE44CONNECT Manuel de l'utilisateur
11. Help
Display
• Try recharging the battery pack.
• Reset the Units. Unplug both the Units' electrical power, then plug them back in.
• Is the Unit switched on?
• Press and hold the ON/OFF button 0 on the Parent Unit for 3 seconds to
switch it ON.
• Is the correct camera selected? Change the camera number, if necessary.
• Is the video display turned on? Press the VIDEO ON/OFF button
V to turn it ON.
• When operating using batteries only, the display will go blank after 5 minutes or
30 minutes or 60 minutes to save power (depending on video settings). The Unit
is still active and will give you audio alerts. You can reactivate the screen by
pressing any button.
Registration
If the Baby Unit has lost its link with the Parent Unit
• If the Baby Unit is too far away it may be going out of range, so move the
Baby Unit closer to the Parent Unit.
• Reset both the Parent Unit and Baby Unit by disconnecting them from the
electrical power. Wait about 15 seconds before reconnecting. Allow up to one
minute for the Baby Unit and the Parent Unit to synchronize.
• See 2.3 Registration (Pairing), if there is a need to re-register the Units.
Interference
Noise interference on your Parent Unit
• Your Baby and Parent Units may be too close. Move them further apart.
• Make sure there is at least 1 to 2m between the 2 Units to avoid audio
feedback.
• lf the Baby Unit is too far away, it may be out of range. Move the Baby Unit
closer to the Parent Unit.
28
Help