Epson Powerspan DT Manuel d'information sur les produits - Page 10

Parcourez en ligne ou téléchargez le pdf Manuel d'information sur les produits pour {nom_de_la_catégorie} Epson Powerspan DT. Epson Powerspan DT 12 pages. Product information guide

Epson Powerspan DT Manuel d'information sur les produits
EPSON PowerSpan DT
Error
messages (continued)
drive controller; check all appropriate connections
drive contmfler; check all appropftate connections
the ~syboard optlon In Setup to
OFF
ON BOARD
ISA NMI messages
ISA NMI meeeage
Memory Parity Error at
Memory failed; if the memory location can be
determined. it ie d&Wed ae xxxxx if not, the
message Is I/o Card Paffty Ermr 7717
DMA Bus Time-out
A device has driven the DMA bus signal for more
than 7.8 microseconds
EPSON PowerSpan DT - 10
BOARD PARITY ERROR ADDR
PARITY

Tested Operating Environments

Although the system will run most software applications,
the following operating environments
compatibility with this system.
Microsoft MS-DOS
Novell DR DOS 6.0
Novell NetWare 2.2,3.12, and 4.01
Novell NetWare Lite 1.1
IBM OS/2 2.1
Microsoft Windows 3.0 and 3.1
Microsoft Windows for WorkGroups 3.11
Microsoft Windows NT 3.1
LAN Manager
This system has also received Novell's 'Yes, NetWare tested
and approved" certification as a workstation and file server.
As new environments become available, these also will be
tested and certified.
Installation/Support Tips
System Power Requirements
If the power cord supplied with the system is not compatible
with the electrical outlet, obtain a cord that
criteria:
rating of the AC voltage system.
an appropriately designed male grounding-type
connector.
IEC type CEE-22 female connector.
Do not use or attempt to modify the supplied AC power cord
if it is not the type required for use in your region.
To avoid permanent damage to the computer, be sure the
voltage selector switch is set to the correct input line voltage
before you turn on the power. Verify that the voltage selector
switch is set to the correct setting. The 115 VAC setting is
appropriate for line source voltages between 100 and 120
VAC. If the line source voltage in your location is between
200 and 240 VAC, make sure you set the switch to 230 VAC.
To avoid damage to the
not exceed a total of 145 Watts power draw.
3/94
been tested for
have
meets these
board or power supply, do
system
?