Motorola C1004 Manuel de l'utilisateur - Page 32

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Motorola C1004. Motorola C1004 44 pages. C12 series

9. Using additional handsets

You can register up to five handsets to your C12 base to extend your phone

system without having to install extension sockets for each new phone.

Each C12 handset can be registered with up to four bases. You can then

select the base you prefer to use.

If you have purchased a C12 multiple pack, all additional handsets come pre-

registered to the base.

If you have purchased an additional handset separately, you must register it

to your C12 base before it can be used.

9.1

NOTE

Handset batteries must be fully charged before you start to register. Hold

your handset close to the base during the registration process. Handsets that

were supplied with your C12 base are already pre-registered.

On the base:

1. Press and hold

remain in registration mode for 90 seconds.

On the handset:

1. Press

, scroll

2. Scroll

REG BASE

3. Enter the base number (1 - 4).

The base numbers that are already in use flash.

4. The display shows SEARCHING...X, where

identification number.

5. The display will ask for the PIN to be entered. Enter the 4 digit PIN code

(default = 0000) and press

is successful. The handset is automatically assigned an available handset

number. Use this number when making internal calls.

NOTE

If registration is not successful the first time, please repeat the process again

in case the base registration period ran out of time. If the base is not found

after a few seconds, the handset returns to standby. Try registering again.

If there are already 5 handsets registered to the base, the registration will

fail. You must de-register another handset before you can register a new one.

Using additional handsets

for 3 seconds until you hear two beeps. The base will

and press

. You will hear a beep if the registration

indicates the base