Motorola D212 Manuel de l'utilisateur - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Motorola D212. Motorola D212 32 pages. Digital cordless phone
Également pour Motorola D212 : Fiche technique (2 pages)

Imprimer la page
Motorola D212 Manuel de l'utilisateur
Allegro_CID TAD.book Page 20 Tuesday, January 15, 2008 4:30 PM
"KEY TONE"
"BATTERY LOW"
"RANGE ALARM"
Press
.
5. Press
or
to select "ON" or "OFF". Press

Flash

Recall is used when connected to certain switchboards, for
transferring calls to another extension number, and for some
network services. Contact your network or switchboard
provider for advice on how to use the

Changing the flash time

You can select the flash time from short or long according to
your switchboard requirements.
Consult your switchboard provider for advice if unsure which
setting you need.
1. Press
to access the main menu.
until "BS SETTINGS" is displayed and press
2. Press
or
.
to select "FLASH TIME" and press
3. Press
or
4. Press
or
to select "SHORT" or "LONG" and press

Dial mode

You can set your phone to use either Tone or Pulse dialling.
The pre-set setting is TONE dialling, where you will hear a tone
beep each time you dial a number.
Most modern exchanges and switchboards use Tone dialling,
20
so you should not need to change this setting. Only change it
if your switchboard uses Pulse dialling or if you cannot make a
call using Tone dialling.
1. Press
2. Press
to confirm.
3. Press
4. Press

Registering a new handset

(flash) button.
When you register a new handset to your base, you will be
asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish to change this code,
see page 21.
Each handset can only be registered to one base at a time.
Before registering, make sure the new handset is fully charged
and that you have the base and handset in front of you.
On your base:
1. Press and hold
are now in 'subscription mode'.
On the handset you want to register:
.
2. Press
.
3. Press
4. Press
If the base already has the maximum number of handsets (5)
registered to it, you will hear the reject tone and you will need
to de-register one of the existing handsets before you can
register the new handset.
See the next section below for de-registering handsets.
to access the main menu.
until "BS SETTINGS" is displayed and press
or
.
to select "DIAL MODE" and press
or
or
to select "TONE" or "PULSE" and press
until you hear the registration tone. You
to access the main menu.
or
to select "REGISTRATION" and press
or
to select your base number.
.
.
.