Motorola XPR 4350 Manuel d'installation - Page 31
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Motorola XPR 4350. Motorola XPR 4350 45 pages.
Imprimer la page
Options and Accessories Installation: Dash-Mount Accessory Installation
3.2.2
Horn and Lights (External Alarm) Relay
For installations that use the horn/lights option, select a suitable location for mounting (normally
under the dash) and, referring to
1. Horn Relay—Connect the relay contacts across the horn ring switch, typically found in the
steering column. Open the accessory cable connector and connect the two control wires
(male pins) into locations 26 and 7 of the connector.
2. Lights Relay—Connect the relay across the headlamp ON/OFF switch, typically found in the
steering column. Open the accessory cable connector and connect the two control wires
(male pins) into locations 26 and 7 of the accessory connector.
3. Squeeze the covers together bending the wires in the strain-relief features. You may need a
pair of pliers to seat the assembly covers.
4. Once the covers are fully seated, fasten them with the cover screws. Tighten the screws
firmly but do not over-tighten them. Be sure none of the wires are pinched.
5. Reattach the accessory connector assembly to the back of the radio and fasten it by finger-
tightening the jackscrews to prevent any loosening.
6816812H01
Figure
3-3, perform the following procedure:
CONNECT
ACROSS HORN
RING SWITCH
AND/OR HEAD LAMP SWITCH
APM 2 (1-wire)
Tx Audio
Aux Audio Out 1 / RxD
Aux Audio Out 2 / TxD
GP5_1 (PTT)
GP5_2 (Monitor)
GP5_3 (Chan Act)
Emerg Sw
Ign Sense
Figure 3-3. Horn/Light Wiring Diagram
SPST
N.O.
RELAY
VIP OUT 1
12V COIL
SWB+
D+
D-
Vbus
USB / APM Ground
APM 1 (1-wire)
SW B+
Power Ground
Spkr-
Spkr+
Audio Ground
Rx Audio
Ground
Ground
GP5_6
GP5_7
GP5_8
VIP_1 (Ext Alarm)
PIN 26
PIN 7
ACCESSORIES
CONNECTOR
March 23, 2006
3-3