Motorola GP340 ATEX Informations sur les services - Page 9

Parcourez en ligne ou téléchargez le pdf Informations sur les services pour {nom_de_la_catégorie} Motorola GP340 ATEX. Motorola GP340 ATEX 24 pages. Professional radio, power distribution and controller
Également pour Motorola GP340 ATEX : Fiche technique (5 pages), Manuel de l'utilisateur (31 pages), Fiche technique (2 pages), Manuel de l'utilisateur (30 pages), Manuel de l'utilisateur (30 pages), Manuel d'utilisation de base (10 pages), Informations sur les services (32 pages), Informations sur les services (30 pages), Informations sur les services (26 pages), Informations sur les services (31 pages), Informations sur les services (43 pages), Informations sur les services (30 pages)

1.0

Introduction

This chapter provides a detailed theory of operation for the radio RF circuits. Refer to the relevant

section of this manual for details of the operation of the Controller Circuits.

2.0

(Refer to Figure 2-1 and the Lowband Transmitter schematic diagram)

The Lowband transmitter consists of the following basic circuits :

Antenna switch/harmonic filter.

Antenna matching network.

Power Control Integrated Circuit (PCIC).

2.1

Power Amplifier (PA)

The power amplifier (PA) consists of two LDMOS devices:

PA driver IC, U101.

PA final stage, Q100.

The LDMOS driver (U101) provides 2-stage amplification using a supply voltage of 7.3V. The

amplifier is capable of supplying an output power of 0.3W (pins 6 and 7) with an input signal of 2mW

at (pin16). The current drain is typically 120mA while operating in the frequency range of

29.7 - 50 MHz. The power output of this stage is varied by the power control loop which controls the

voltage on pin 1.

SPI Bus

P C I C

V Control

Power Amplifier (PA)

PA Driver

Figure 2-1 Lowband Transmitter Block Diagram.

THEORY OF OPERATION

Antenna switch bias

Gate bias

Antenna Switch/

PA Final

Harmonic Filter

Stage

Chapter 2

Antenna

Matching

Network